Epson DFX-9000 - Page 256

Epson DFX 9000 Revision B
Adjustment Software adjustment 249
4. Measure the distance (mm), from the bottom edge of the paper to the
center of the bottom dot of the printed pattern, as shown in Figure
5-32. If it is within the specified range, no adjustment is needed.
Click Finish.
Figure 5-32. Bottom margin check pattern
5. If it is out of range, refer to the table below and input an adjustment
value that will move the margin into the specified range.
6. Click Write to save the new parameter for the next test print.
7. Click Print to print the check pattern with the new parameter.
8. Repeat Step 4 to Step 7 until the bottom margin is within
specifications.
Paper mode
To increase
bottom
margin
To decrease
bottom
margin
Target margin
Normal paper mode 1 ~ 40 -1 ~ -40 2.1 ~ 3.1 mm
(0.08 ~ 0.12 in.)
Black paper mode 1 ~ 80 -1 ~ -80 2.6 ~ 4.6 mm
(0.10 ~ 0.18 in.)
C H E C K
P O I N T
To estimate the adjustment value to enter, use this formula:
1 step = 0.059 mm (1/432 inch).
Example:
A value of 9 increases the bottom margin by 0.53 mm.
Center pattern
Dot center
Measurement
distance