3. Press the
Operate
button to turn on the printer, if necessary.
4. Slide the left edge guide until it locks in place next to the triangle
mark on the paper guide. Next adjust the right edge guide to
match the width of your paper.
5. Load a sheet of paper printable side up between the edge
guides until it meets resistance. The printer feeds the paper
automatically and is ready to print.
If the first line on your page appears too high or low, you can
fix this by adjusting the top-of-form position using the micro
adjust feature. See “Adjusting the Top-of-Form Position” on
page 3-30.
G4-4-1
G4-4-2
L
Gentian Rev.c
A5 size Chapter 4
97/06/20 pass 0
4-4
Printing on Single Sheets
To Next Page
Loading...
