Using the EPSON Remote! utility
The EPSON Remote! utility allows you to easily change the
printer’s default settings from your computer.
Installing EPSON Remote!
Follow the steps below to install EPSON Remote!.
1. Insert Disk 1 of your printer driver software in a disk drive.
2. From the DOS prompt, type
A:\SETUP. (
If you inserted the
driver disk in a drive other than drive A, substitute the
appropriate letter.
)
Then press
Enter
.
3. Select your printer’s name in the Printer Model window and
press
Enter
.
C:\EPUTIL
appears as the default directory.
4. Press
Enter
again. The EPSON Remote! utility is copied to
C:\EPUTIL.
Accessing EPSON Remote!
To access EPSON Remote!, type
C:\PRNSET
at the DOS prompt
and press
Enter
. Then follow the on-screen instructions to use
this utility.
L
Gentian Rev.c
A5 size Chapter 2
06/20/97 pass 2
2-20
Setting Up Your Software
To Next Page
Loading...
