no
Draft
fo
Draft Condensed
nn
Roman
fn
Roman Condensed
nf
Sans Serif
ff
Sans Serif Condensed
n
=On,
f
=Flashing,
o
=Off
4. M
ake sure that
the font you want is selected, and then press
the
Pause
button to exit the font selection mode.
Making Default Settings
The default settings control many printer functions. While you
can often set these functions through your software or printer
driver, you may sometimes need to change a default setting
from the printer’s control panel using the default-setting mode.
For a detailed description of the settings you can change in the
default-setting mode, see the following. For instructions on
changing the settings, see “Changing default settings” later
in this chapter.
Understanding default settings
This section describes the settings and options available in the
default-setting mode. These settings are divided into two
groups, as shown in the tables below. The settings are
explained in more detail after each table.
To access and change a setting, note the group (1 or 2) it is in,
check its description in the next pages for more information,
then see the section on changing default settings at the end of
this chapter.
5
R
Gentian Rev.c
A5 size Chapter 5
07/07/97 pass 4
Changing Printer Settings From the Printer’s Control Panel
5-3
To Next Page
Loading...
