After a few seconds, the printer loads the paper automatically,
and then begins printing the self test. A series of characters is
printed.
Note:
To temporarily stop the self test, press the
Pause
button. To resume
the test, press the
Pause
button again.
3. To end the self test, press the
Pause
button to stop printing.
If paper remains in the printer, press the
Load/Eject
button
to eject the printed page. Then turn off the printer.
c
Caution:
Do not turn off the printer while it is printing. Always press the
Pause
button to stop printing and the
Load/Eject
button to
eject the printed page before you turn off the printer.
Printing a Hex Dump
If you are an experienced user or a programmer, you can print
a hexadecimal dump to isolate communication problems
between the printer and your software program. In hex dump
mode, the printer prints all data it receives from the computer
as hexadecimal values.
You can print a hex dump using either single sheets or
continuous paper. See Chapter 3 for instructions on loading
continuous paper, or Chapter 4 for instructions on loading
single sheets.
Note:
Use 210 mm (8.3 inches) or wider paper such as A4 or letter size.
To print a hex dump, follow the steps below.
1. Make sure that paper is loaded, and the printer is turned off.
L
Gentian Rev.c
A5 size Chapter 8
97/06/20 pass 1
8-16
Troubleshooting
To Next Page
Loading...
