Using the Tractor in the Pull Position
To install the tractor in the pull position, you need to remove
the paper tension unit and install the tractor in its place. Follow
the steps below.
Removing the paper tension unit
1. Make sure that the printer is off, and remove the printer cover.
2. Press up the tabs on each side of the paper tension unit and lift
the unit up and off the printer. Store the paper tension unit in
a safe place.
G1-6
G1-6-2
L
Gentian Rev.c
A5 size Chapter 3
97/07/04 pass 2
3-18
Printing on Continuous Paper
To Next Page
Loading...
