Advancing paper to the tear-off position
automatically
To automatically advance your printed documents to the
tear-off position, turn on the auto tear-off mode and select the
appropriate page length for continuous paper in the default
setting mode. When auto tear-off is on, the printer
automatically advances the paper to the tear-off position
whenever it receives a full page of data or a form feed
command followed by no more data. To enter the default-setting
mode, see “Making Default Settings” on page 5-3.
Adjusting the tear-off position
If your paper’s perforation is not aligned with the tear-off edge,
you can use the micro adjust feature to move the perforation to
the tear-off position. Follow the steps below.
Note:
Your tear-off position setting remains in effect until you change it, even
if you turn off the printer.
1. Make sure the
Tear Off/Bin
light is flashing (the paper
is at the current tear-off position). You may need to press
the
Tear Off/Bin
button to advance the paper to the tear-off
position.
g3-22aa
L
Gentian Rev.c
A5 size Chapter 3
97/07/04 pass 2
3-28
Printing on Continuous Paper
To Next Page
Loading...
