2. Hold down the
Pause
button for about three seconds.
The
Pause
light begins flashing and the printer enters
the micro adjust mode.
3. Press the
LF/FF
D
button to feed paper backward, or press
the
Load/Eject
U
button to feed paper forward, until
the paper perforation is aligned with the tear-off edge of the
printer cover.
Note:
The printer has a minimum and a maximum tear-off position. If you
try to adjust the tear-off position beyond these limits, the printer
beeps and stops moving the paper.
4. Tear off the printed pages.
5. Press the
Pause
button to turn off micro adjust mode.
When you resume printing, the printer automatically feeds the
paper back to the top-of-form position and begins printing.
c
Caution:
Never use the knob to adjust the tear-off position; otherwise you
may damage the printer or lose the tear-off position.
G3-22-2
3
R
Gentian Rev.c
A5 size Chapter 3
97/07/04 pass 2
Printing on Continuous Paper
3-29
To Next Page
Loading...
