If the first line on your page appears too high or low, you can
fix this by adjusting the top-of-form position using the micro
adjust feature. See “Adjusting the Top-of-Form Position” on
page 3-30.
Loading paper in the high-capacity cut-sheet feeder
The high-capacity cut-sheet feeder holds up to 150 sheets of
paper or up to 25 envelopes.
c
Caution:
Do not load multi-part forms, carbon paper, or labels in the
high-capacity cut-sheet feeder.
1. Set the paper release lever to the single-sheet position. Also
make sure the paper thickness lever (located under the printer
cover) is set to 0 if you are using ordinary single-sheet paper.
(If you are using envelopes, see “Loading Envelopes” on page
4-22 for instructions on setting the paper release lever.)
-1
1
2
3
4
5
6
G4-6-3
4
Gentian Rev.c
A5 size Chapter 4
97/06/20 pass 0
Printing on Single Sheets
4-11
To Next Page
Loading...
