7. Push back the paper set levers to clamp the paper against the
guide rollers.
8. Attach the stacker-support wires to the paper guide as shown
below, if necessary.
9. Install the paper guide with the attached stacker-support by
fitting the notches on the paper guide straight down over the
mounting posts on the printer. Slide the edge guides to the
middle of your paper.
The cut-sheet feeder automatically loads paper when the
printer receives data.
G4-7-1
G4-9
L
Gentian Rev.c
A5 size Chapter 4
97/06/20 pass 0
4-10
Printing on Single Sheets
To Next Page
Loading...
