Using the Optional Cut-Sheet Feeders
Two types of optional cut-sheet feeders are available for use
with your printer: the single-bin cut-sheet feeder (C80637 ) and
the high-capacity cut-sheet feeder (C80638 ). You can use
either one of these separately, or you can use both feeders
together as a double-bin cut-sheet feeder to automatically load
two different types of paper.
The single-bin cut-sheet feeder holds up to 50 single sheets.
The high-capacity cut-sheet feeder holds up to 150 single sheets
or up to 25 envelopes.
c
Caution:
Do not load multi-part forms, carbon paper, or labels in the
cut-sheet feeder.
To install the single-bin, high-capacity, or double-bin cut-sheet
feeder, see the next section. However, before installing the
double-bin cut-sheet feeder, you must assemble it as described
a page 4-14. To load paper in a bin, see “Loading paper in the
single-bin cut-sheet feeder” on page 4-7, or “Loading paper in
the high-capacity cut-sheet feeder” on page 4-11.
Note:
You cannot install and use the optional cut-sheet feeders when the tractor
unit is installed in the pull position. To remove the tractor from the pull
position, see page 3-20.
Installing an optional cut-sheet feeder
You install the single-bin, high-capacity, and double-bin
cut-sheet feeders in the same way. Follow the steps on the next
page.
Note:
Before you install the double-bin cut-sheet feeder, you need to assemble it
as described on page 4-14.
4
Gentian Rev.c
A5 size Chapter 4
97/06/20 pass 0
Printing on Single Sheets
4-5
To Next Page
Loading...
