If the first line on your page appears too high or low, you can
fix this by using the micro adjust feature as described in
“Adjusting the Top-of-Form Position” on page 3-30.
c
Caution:
Never use the knob to adjust the top-of-form position; this may
damage the printer or cause it to lose the top-of-form position.
Removing paper from the front push tractor
1. To remove continuous paper, press the
Tear Off/Bin
button to
feed the paper’s perforation to the tear-off edge of the printer
cover.
Note:
If your paper’s perforation is not properly aligned with the tear-off
edge, you can adjust the tear-off position using the micro adjust
feature as described in “Adjusting the tear-off position” on page 3-28.
2. Tear off the printed document using the tear-off edge of the
printer cover.
3. Press the
Load/Eject
button to feed the continuous paper
backward out of the printer and into the standby position.
c
Caution:
Make sure you tear off your printed document before pressing the
Load/Eject
button. Reverse feeding several pages at a time may
cause a paper jam.
3
R
Gentian Rev.c
A5 size Chapter 3
97/07/04 pass 2
Printing on Continuous Paper
3-11
To Next Page
Loading...
