Switching to Printing on Continuous Paper
You can easily switch back and forth between printing on
continuous paper and printing on single sheets without having
to remove or reload the continuous paper. This easy switching
capability is available any time a tractor is installed in the front
or rear push position.
To switch from printing on single sheets to printing on
continuous paper, see the following. To switch from printing
on continuous paper to printing on single sheets, see page 3-32.
Note:
To switch from printing with the optional front sheet guide to printing
with the push tractor installed in the front push position, you need to
remove the front sheet guide.
1. If a single sheet remains in the printer, press the
Load/Eject
button to eject it.
c
Caution:
Never use the knob to eject paper; this may damage the
printer or cause it to lose the top-of-form position.
2. Make sure that the tractor is installed in the front or rear push
position and that continuous paper is loaded on the tractor.
See Chapter 3 for instructions.
3. Make sure that the paper release lever is set to the front or rear
push position, depending on the tractor position you are using.
Your printer loads the continuous paper automatically when
you begin printing.
4
Gentian Rev.c
A5 size Chapter 4
97/06/20 pass 0
Printing on Single Sheets
4-23
To Next Page
Loading...
