Loading Envelopes
You can load envelopes one at a time using the paper guide
on the top of the printer, or you can load multiple envelopes
using the optional high-capacity cut-sheet feeder (bin 1 of the
double-bin cut-sheet feeder).
Before loading envelopes, set the paper thickness lever to a
position from 2 to 6 depending on the thickness of the
envelope; position 2 is for thin envelopes and position 6 is for
thick envelopes.
To load single envelopes, follow the instructions in “Loading
paper in the paper guide” on page 4-3. To load multiple
envelopes, see “Loading paper in the high-capacity cut-sheet
feeder” on page 4-11.
Note:
❏
Place the envelope printable side down and insert the top edge of
the envelope into the printer first.
❏
The print head must not print past the left or right edge of the
envelope or other thick paper. Make sure your application
program prints entirely within the printable area of the envelope
you are using. See Appendix B for more information on the
printable area of envelopes.
❏
If you are using No. 6 envelopes, make sure the left edge guide is
aligned with the arrow on the paper guide.
G4-21
L
Gentian Rev.c
A5 size Chapter 4
97/06/20 pass 0
4-22
Printing on Single Sheets
To Next Page
Loading...
