1. Insert Disk 1 of the EPSON Status Monitor 2 software in a
floppy disk drive.
2. Click
START
and
Run
.
3. Type
A:\Setup
(if you inserted the disk in a drive other than
drive A, substitute the appropriate letter) and click
OK
.
4. Follow the on-screen instructions, then click
FINISH
to complete
the installation procedure.
See Chapter 6 for instructions on using the EPSON Status
Monitor 2 utility.
For Windows 3.1 Users
Installing the printer driver
Follow the steps below to install the printer driver for
Windows 3.1.
1. Make sure Windows 3.1 is running and the Program Manager
window is open.
2. Insert Disk 1 of your printer driver software in a disk drive.
3. Choose
Run
from the File menu. The following dialog box
appears:
31run
L
Gentian Rev.c
A5 size Chapter 2
06/20/97 pass 2
2-8
Setting Up Your Software
To Next Page
Loading...
