Printer Specifications
Mechanical
Printing method: 9-pin impact dot matrix
Printing speed: High speed draft 410 cps at 10 cpi
(max. 455 cps at 12 cpi)
Draft 310 cps at 10 cpi
Near letter quality 77 cps at 10 cpi
Printing direction: Bidirectional logic seeking for text and
graphics printing. Unidirectional text or
graphics printing can be selected using
software commands.
Line spacing: 1/6-inch or programmable in 1/216-inch
increments
Printable columns: 80 columns (at 10 cpi)
Resolution:
Maximum 240 × 144 dpi (near letter quality)
Interfaces: One standard bidirectional, 8-bit, parallel
interface with IEEE 1284 nibble mode
support and one optional interface slot.
Paper feed methods: Friction (front, rear)
Push tractor (front, rear)
Pull tractor (front, bottom, rear)
Push and pull tractor (additional tractor is
required)
Cut-sheet feeder (optional)
Roll paper holder (optional)
Paper feed speed: Continuous 5 inches/second
Intermittent 62 ms/line at 1/6-inch line
spacing
L
Gentian Rev.c
A5 size Appendix B
97/06/17 pass 3
B-2
Specifications
To Next Page
Loading...
