3. Lower the tractor into the printer’s mounting slots and press
down both ends of the tractor to make sure that it is firmly
seated.
See the next section for instructions on loading continuous
paper with the rear push tractor.
To remove the tractor, first remove any paper from it as
described on page 3-17. Then remove the paper guide, and
press the tractor’s lock tabs and tilt the tractor up and off
the printer.
Loading paper with the rear push tractor
1. Make sure the printer is turned off and the paper guide is
removed. Also make sure the tractor is installed in the rear
push position.
G3-12
g3-15
3
R
Gentian Rev.c
A5 size Chapter 3
97/07/04 pass 2
Printing on Continuous Paper
3-13
To Next Page
Loading...
