3. To change settings in default-setting mode 1, hold down the
Tear Off/Bin
button while you press the
Operate
button to
turn on the printer. To change settings in default-setting mode
2, hold down the
Tear Off/Bin
and
LF/FF
buttons while you
press the
Operate
button to turn on the printer.
The printer enters the default-setting mode you selected and
prints the language selection instructions (one page).
4. Press the
Load/Eject
button until the
Paper Out
and
Pause
lights indicate the language you want, as described in the
language selection instructions.
5. Press the
Tear Off/Bin
button to print the default-setting
mode instructions (two pages) in the language you selected.
The printed instructions list the settings you can change,
describe how to change them, and show you how the control
panel lights help you make settings. Use these instructions to
change the printer’s default settings from the control panel.
Note:
The arrows in the instructions indicate the printer’s current settings.
6. When you finish making settings, press the
Operate
button to
turn off the printer and exit the default-setting mode.
Note:
You may exit either default-setting mode any time by turning off the
printer while the printer is paused. Any settings you have made remain
in effect until you change them again.
5
R
Gentian Rev.c
A5 size Chapter 5
07/07/97 pass 4
Changing Printer Settings From the Printer’s Control Panel
5-9
To Next Page
