❑
Unplug the printer and refer servicing to qualified service
personnel under the following conditions:
If the power cord or plug is damaged; if liquid has entered the
printer; if the printer has been dropped or the cabinet
damaged; or if the printer does not operate normally or
exhibits a distinct change in performance. Adjust only those
controls that are covered by the operating instructions.
❑
Do not touch any printer parts marked with this symbol.
The part may be hot. Turn off the printer and let it
cool for a few minutes before you touch a printer part
marked with this symbol.
❑
If you plan to use the printer in Germany, observe the
following:
To provide adequate short-circuit protection and over-current
protection for this printer, the building installation must be
protected by a 16 Amp circuit breaker.
Note for German-speaking users:
Bei Anschluß des Druckers an die Stromversorgung muß
sichergestellt werden, daß die Gebäudeinstallation mit einem 16
A-Überstromschalter abgesichert ist.
K
R
Gentian Rev.c
A5 size Introduction
97/07/04 pass 1
Getting to Know Your Printer
9
To Next Page
Loading...
