4. Press the
LF/FF
D
button to move the top-of-form position up
on the page, or press the
Load/Eject
U
button to move the
top-of-form position down on the page.
Note:
❏
The printer has a minimum and a maximum top-of-form
position. If you try to adjust it beyond these limits, the
printer beeps and stops moving the paper.
❏
When the paper reaches the default top-of-form position,
the printer also beeps and stops moving the paper briefly. You
can use the default setting as a reference point when
adjusting the top-of-form position.
5. After you set the top-of-form position, press the
Pause
button
to exit micro adjust mode.
G3-29
3
R
Gentian Rev.c
A5 size Chapter 3
97/07/04 pass 2
Printing on Continuous Paper
3-31
To Next Page
Loading...
