Epson LX-300+ - Page 83

LX-300+/1170 Revision C
Disassembly and Assembly Disassembly and Assembly 83
Figure4-15. Carriage Unit Removal
5. Rotate the right and left parallelism adjust bushing and remove them from respective
frame.
6. Release the PG adjust lever hook, connecting to the left frame.
Figure4-16. Hook at the PG Adjust Lever
7. Remove the carriage unit along with the CR guide shaft and PG adjust lever from the
printer mechanism.
PG adjust lever
CR guide shaft
Carriage unit
Right frame
CR guide grounding plate
Left frame
Base frame
Parallelism adjust bushing
Oil pad
Parallelism adjust bushing
A D J U S T M E N T
R E Q U I R E D
When the carriage unit is replaced, perform Bi-D adjustment.
PG Adjust Lever -- Hook