Epson RC90 Safety And Installation

2. Installation
Safety and Installation (RC90 / EPSON RC+ 7.0) Rev.6
55
LS6
only
(2)
Using nippers, cut off the wire tie
binding
the shaft and arm retaining
bracket on the
base.
Bolt
M4×20
Wire tie
Bolt
M4×20
LS6
only
(3)
Remove the bolts securing the wire
ties removed in step (2).
Remove the fixing sheet for
transportation which is attached to
the arm.
Make sure to
remove the wire tie
for protection of mechanical stop.

NOTE

Epson RC90 Specifications

General

Brand	Epson
Model	RC90
Category	Controller
Language	English