U “Supported Media” on page 118
A
Remove the black flange with the attachment
from the spindle.
B
Push out the two hooks that fit into the flange.
When the hooks have been released, you can
remove the attachment.
C
In the same way, push out the hooks and remove
the attachment from the flange that is fixed to the
spindle.
You need the attachment you removed when
printing on roll paper with a 3 inch roll core, so
make sure you store it in a safe place.
Installing the attachment
To use roll paper with a 3 inch roll core, you need to
install the attachment on the flange.
U “Supported Media” on page 118
A
Remove the black flange from the spindle.
B
Align the triangle marks on the attachment and
the flange, and press until the hooks click into
place.
C
In the same way, insert the attachment into the
spindle first, and then attach it to the flange that is
fixed to the spindle.
Loading roll paper on the spindle
Load roll paper on the spindle supplied with the roll
paper unit.
A
Make sure that the corners of the roll paper being
loaded are right angles.
If the corners of the roll paper are not right
angles, trim before proceeding.
B
Remove the black flange from the spindle.
SC-P800 Series User’s Guide
Basic Operations
31
To Next Page
Loading...
Need help?
General
