68
10. Close the ink cartridge cover and press it until it clicks into place.
11. Close the scanner.
12. Press the ink button. The Epson Stylus CX begins charging ink and the On
light starts flashing. This takes about one minute. When it’s finished, the On
light stops flashing and remains on, and the ink light goes out.
Caution: Never turn off the Epson Stylus CX while the On light is flashing or
you’ll waste ink.
Note: If the ink light stays on (not flashing), the ink cartridge may not be
installed correctly. Press the ink button again and reinstall the ink cartridge
until it clicks into place.
To Next Page
Loading...
