Epson Stylus Photo RX700 - ASF Rear Assy

EPSON Stylus Photo RX900 Revision A
Disassembly and Assembly Disassembly and Assembly of Major Parts of Printer 103
4.4.1 ASF Rear Assy
1. Remove the Middle Housing. (p.88)
2. Remove the screw, and remove the LD Roller Guide and spacer.
3. Remove the Paper Block Levers (x2) upward.
4. Remove all the connectors connected to the Relay Connectors.
5. Remove the screw, and remove the Nylon Clip.
6. Disconnect all the cables from the ASF Rear Assy.
7. Remove the right and left screws (x2).
8. Disengage the hooks (x2) on the CR Motor side and the hooks (x2) on the front side,
and remove the ASF Rear Assy.
(Continued to next page)
Figure 4-35. Removing the ASF Rear Assy
LD Roller Guide
Torque: 0.8 ± 0.1N
⋅m
C.B.S-Tite 3x6 F/ZN-3C
Spacer
ASF Rear Assy
Hooks (x2)
Torque: 0.6 ± 0.1N
⋅m
C.B.S-Tite(P4) 3x6 F/ZN-3C
Screw
Nylon Clip
Hooks (x2)
Paper Block Lever (x2)
SHAFT ATTACHMENT BOARD CR-3C
Disconnect the
lead wires
Remove from the
release unit shank