Epson Stylus Photo RX700 - Power Supply Board

EPSON Stylus Photo RX900 Revision A
Disassembly and Assembly Disassembly and Assembly of Major Parts of Printer 109
4.4.5 Power Supply Board
1. Remove the Printer Mechanism. (p.107)
2. Disconnect the connector (CN2) from the Power Supply Board, and remove the Power
Supply Unit from the Lower Case.
3. Remove the screw, and remove the TPU Connector Cover.
4. Remove the screws (x4) securing the Upper P/S Shield Plate.
5. Remove the ground screw.
6. Remove the screws (x5) securing the Power Supply Board, and remove it from the
Lower P/S Shield Plate.
Figure 4-43. Removing the Power Supply Board
A D J U S T M E N T
R E Q U I R E D
Adjustments are required. When the Power Supply Board has
been replaced with a new one, refer to the following section and
perform the necessary adjustments.
 5.1.1 Adjustment Items (p.134)
電源ユニット
TPU Connector Cover
Torque: 0.5 ± 0.1N
⋅m
C.B.S-Tite 3x6 F/ZN-3C
Upper P/S Shield Plate
Torque: 0.6 ± 0.1N
⋅m
C.B.S-Tite 3x6 F/ZN (x4)
Nut
Torque: 0.8 ± 0.1N
⋅m
C.B.(O) 4x5 F/ZG-3C
Power Supply Board
Torque: 0.8 ± 0.1N
⋅m
C.B.S-Tite 3x6 F/ZN (x5)