Epson Stylus Photo RX700 - Rear Paper Guide Assy; Chapter 4 Disassembly and Assembly

EPSON Stylus Photo RX900 Revision A
Disassembly and Assembly Disassembly and Assembly of Major Parts of Printer 114
4.4.10 Rear Paper Guide Assy
1. Remove the Printer Mechanism. (p.107)
2. Remove the screws (x2) securing the Paper Feed Lower Cover at the bottom of the
printer.
(See Figure 4-50)
3. Disengage the hooks (x2) on the PF Motor side, and remove the Paper Feed Lower
Cover from the printer frame.
4. Disengage the hook on the PF Motor side, and remove the Rear Paper Guide Assy.
5. Remove the screw on the Projection side, and remove the Paper Guide Bank
Separation from the Paper Feed Lower Cover.
Figure 4-50. Removing the Rear Paper Guide Assy
Figure 4-51. Paper Guide Bank Separation
 Lubrication is necessary. Refer to the following section and
lubricate the specified points:
Lubrication of Driven Pulley Assy (p.154)
 Install the Paper Guide Bank Separation, so that the projection
of the Paper Feed Lower Cover enters the hole in the Paper
Guide Bank Separation. (See Figure 4-51)
給紙下カバー
Paper Feed Lower Cover
Torque: 0.6 ± 0.1N
⋅m
Rear Paper Guide Assy
C.B.P-Tite 3x6 F/ZN-3C
Hook
C.B.S-Tite 3x6 F/ZN-3C
Torque: 0.8 ± 0.1N
⋅m
Paper Feed Lower Cover
Paper Guide Bank Separation
Projection