Epson Stylus Photo RX700 - Printer Mechanism

EPSON Stylus Photo RX900 Revision A
Disassembly and Assembly Disassembly and Assembly of Major Parts of Printer 107
4.4.4 Printer Mechanism
1. Remove the Middle Housing. (p.88)
2. Remove the ASF Rear Assy. (p.103)
3. Remove the I/C Holder Assy. (p.105)
4. At the rear of the printer, remove the screws (x2) (one of them secures the Power
Supply Assy Shield Plate together).
5. Remove the screws (x2) securing the Harness Clamp.
6. Remove the screws (x5) securing the Printer Mechanism.
7. Release the tube clamps, and disconnect the Waste Ink Tubes (x2) from the Tube
Holder.
8. Remove the Printer Mechanism with care that it is not caught by lead wires.
(Continued to next page)
Figure 4-39. Removing the Printer Mechanism
C A U T I O N
When you remove the Waste Ink Tubes, ink may blow out. Take
great care not to stain any surrounding objects with ink.
When installing the Waste Ink Tubes, make sure that they are all
the way seated in the locations shown below.
Waste Ink Tube (Blue)
Waste Ink Tube (Red)
Tube Holder
Tube clamps (x2)
Torque: 0.8 ± 0.1N⋅m
Torque: 0.6 ± 0.1N⋅m
C.B.P-Tite 3x8 F/ZN-3C (x5)
Printer Mechanism
Harness Clamp
Torque: 0.6 ± 0.1N⋅m
C.B.P-Tite 3x8 F/ZN-3C (x2)
C.B.S-Tite(P4) 3x6 F/ZN-3C
C.B.S-Tite 3x6 F/ZN-3C
Torque: 0.8 ± 0.1N
⋅m
Lower Case Assy