Epson Stylus Photo RX700 - Disassembly and Reassembly Procedure

EPSON Stylus Photo RX900 Revision A
Disassembly and Assembly Overview 79
4.1.4 Disassembly and Reassembly Procedure
The flowchart below shows step-by-step disassembly procedure for Stylus Photo RX700. When disassembling each component, refer to the page number indicated for the relevant
component.
Flowchart 4-1. Disassembly Procedure
START
Panel Assy
(p.80)
Disassembly of Panel Assy
(p.82)
Main Board Unit
(p.86)
Printhead
(p.92)
Middle Housing
(p.88)
Disassembly of Scanner Unit
(p.96)
Disassembly and Assembly of Major Parts of Printer
(p.102)
Linear Scale
(p.91)
Valve Assy (Including Ink Tube Assy)
(p.94)
Pressure Pump Assy
(p.85)
LCD Assy
(p.81)
Disassembly of LCD Assy
(p.81)
C H E C K
P O I N T
 Stylus Photo RX700 does not have any mechanism that permits
the operator to unlock the carriage. Therefore, turn the power
ON and turn it OFF timely after seeing the movement of the
carriage to locate it at a position other than the home position.
 As soon as the repaired product has been returned to the user,
there may be a case a maintenance call occurs because of the
expiration of the life of a service part. Avoid such a case, if
possible, as follows: Check the maintenance counter for
regularly replaced parts before disassembly. If the life of any
part is found almost expired, communicate with the user to that
effect. If the user’s consent is obtained, replace also the relevant
service parts with new ones.
Scanner Unit
(p.83)
Disassembly of TPU Assy
(p.101)
Preparation before Disassembly
(p.78)