Epson Stylus Photo RX700 - 1.2 Common Specifications

EPSON Stylus Photo RX700 Revision B
Product Description Common Specifications 14
1.2 Common Specifications
1.2.1 Electrical Specifications
 Primary power input
Note 1: This product complies with the “Energy Star” standards.
2: If the printer is not operated at all for at least 5 minutes, the standby function reduces
the current to the motor to save power.
3: If the scanner is not operated at all for at least 15 minutes, the standby function reduces
the current to the motor to save power.
 Insulation resistance:
10 MΩ minimum (tested between AC line and chassis, test voltage: DC 500 V)
 Dielectric strength:
AC 1000 Vrms for one minute or AC 1200 Vrms for one second
 Safety Standards/EMC:
VCCI class B
Guideline for the Suppression of Harmonics in Household and General-Use
Equipment
 Other Model-dependent Specifications: None.
1.2.2 Environmental Resistance
Note “*1”:When packed for shipping.
“*2”:No condensation
“*3”:Under the following conditions
Figure 1-1. Environmental Conditions
Table 1-10. Primary Power Input Specifications
100-120 V Model 220-240 V Model
Rated power supply voltage
(ACV)
100-120 220-240
Input voltage range (ACV) 90 ~ 132 198 ~ 240
Rated current (A) 0.8 A (max. 1.1 A) 0.4 A (max. 0.55 A)
Rated frequency (Hz) 50 ~ 60
Input frequency range (Hz) 49.5 ~ 60.5
Power consumption (W)
Approx. 25 W
(Standalone copying,
ISO10561 Letter Patter,
Plain Paper–A4 Text)
Approx. 25 W
(Standalone copying,
ISO10561 Letter Patter,
Plain Paper–A4 Text)
Approx. 12.5 W
(Low-power Mode)
Approx. 12.5 W
(Low-power Mode)
Approx. 2.5 W (Sleep Mode) Approx. 2.5 W (Sleep Mode)
Approx. 0.2 W
(Power Off Mode)
Approx. 0.4 W
(Power Off Mode)
Table 1-11. Environment Resistance Specifications
Item Operation Mode Non-operation Mode
Temperature 10 ~ 35°C *
3
-20 ~ 60°C *
1
1 month when at 40°C
120 hours when at 60°C
Humidity 20 ~ 80%, RH *
2,
*
3
5 ~ 85%, RH *
1,
*
2
Impact 1 G, 1 x 10-3 seconds 2 G, 2 x 10-3 seconds *
1
Vibration 0.15G 0.50G *
1
C H E C K
P O I N T
For storage, make sure that the printhead is capped and ink
cartridges are left mounted.