EPSON Stylus Photo RX900 Revision A
Disassembly and Assembly Disassembly and Assembly of Major Parts of Printer 125
4.4.19 PF Motor
1.
Remove the Printer Mechanism. (p.107)
2. Remove the two screws, and remove the PF Timing Belt and then the PF Motor.
Figure 4-65. Removing the PF Motor
Secure the PF Motor by the following procedure:
1. Tighten the upper screw loosely.
2. Secure the PF Motor temporarily while pulling the PF Motor
obliquely downward to take up the PF Timing Belt.
3. Make the belt tension adjustment specified below for the PF
Motor, and tighten up the screws.
A D J U S T M E N T
R E Q U I R E D
Once the PF Motor has been removed or replaced with a new one,
refer to the following section and perform the necessary
adjustments.
5.1.1 Adjustment Items (p.134)
PF Motor
Torque: 0.4 ± 0.05N
⋅m
C.P. Screw 2.6x3 F/ZN-3C (x2)
PF Timing Belt
~ Rear ~
To Next Page
Loading...
