Epson Stylus Photo RX700 - Page 71

EPSON Stylus Photo RX700 Revision A
Troubleshooting Ink Supply Related Troubleshooting 71
 Ink is not supplied or waste ink is not discharged properly
Table 3-12. Troubleshooting for Faulty Ink Supply or Faulty Waste Ink Discharge
Condition Cause Check Point Remedy
Ink is not flowing from
Printhead to Cap or from
Cap to Ink Tube
Pump tube collapsed Visually check tube. Replace the Ink System Assy
Cap is dirty or damaged.
Check for foreign object adhering to Cap or damaged
Cap.
Remove foreign object in Cap with cotton swab. If Cap is damaged, replace the Ink
System Assy.
Tube is disconnected from
Cap bottom
Visually check for disconnection of tube from Cap
lower bottom.
Connect the tube properly.
Cap does not slide up
properly
Check for installation of compression spring on tube
assembly.
Replace the Ink System Assy with a new one.