223
You see a screen like this:
3. Select Proceed.
4. On the Fax Header screen, use the displayed keypad to enter the sender name for your fax source,
such as your name or a business name. You can enter up to 40 characters. Select OK when you are
done.
5. On the Your Phone Number screen, use the displayed keypad to enter your fax number, up to 20
characters. Select OK when you are done.
Note: The name and phone number in the fax header identifies the source of the faxes you send.
6. On the Distinctive Ring Setting screen, do one of the following:
• If you have subscribed to a distinctive ring service from your telephone company, select Proceed.
Select the ring pattern to be used for incoming faxes or select All. Go to the next step.
• If you do not have a distinctive ring service, select Skip and go to step 9.
Note: Distinctive ring services allows you to have several phone numbers on one phone line. Each
number is assigned a different ring pattern. You can use one number for voice calls and another for
fax calls. Select the ring pattern assigned to fax calls in the DRD Setting. If you select a ring pattern
other than All, Receive Mode is automatically set to Auto.
To Next Page
Loading...
Need help?
General