324
Note: If you are using a CA certificate or Kerberos authentication, it is recommended to use a time
server to set the date and time.
1. Log in to the Web Config interface as an administrator.
2. Select the Device Management tab, then select the Date and Time > Time Server setting.
3. Set Use Time Server to Use.
4. Enter the time server address in Time Server Address. You can use the IPv4, IPv6, or FQDN
format for the address. You are limited to 252 characters.
5. Enter an update interval (up to 10080 minutes) in Update Interval (min).
6. Click OK to update the settings.
Parent topic: Configuring Product Settings
Related references
Digital Certificate Warning Messages
Related tasks
Accessing the Web Config Utility
Clearing the Internal Memory
You can delete the contents of the product's internal memory, such as password-protected print jobs and
downloaded PCL fonts and macros using the Web Config interface. You cannot select individual items to
delete.
1. Log in to the Web Config interface as an administrator.
2. Select the Device Management tab, then select the Clear Internal Memory Data setting.
3. Select Delete and confirm your selection.
Parent topic: Configuring Product Settings
Related references
Job Status Error Codes
Related tasks
Accessing the Web Config Utility
Adjusting the Contact List View Options
You can adjust the way contacts are listed on the product's LCD screen. You can also configure the way
searches are performed when searching the contact list.
To Next Page
Loading...
Need help?
General