332
2. Select the Product Security tab, then select the Domain Restrictions setting.
3. Select a restriction method for the Restriction Rule setting. Select Allow Sending to limit sending
emails to the listed domains or select Deny Sending to prevent emails from being sent to the listed
domains.
4. Add the necessary domains to the list by entering them in the Domain Name field and selecting
Add.
The domain is added to the list. To delete domain, select the checkbox next to the domain name and
select Delete.
5. Select OK to apply your changes.
Parent topic: Configuring Security Settings
Using Your Product on a Secure Network
Follow the instructions in these sections to configure security features for your product on the network
using the Web Config software.
Configuring Protocols and Services in Web Config
Configuring SSL/TLS Communication
Configuring IPsec/IP Filtering
Connecting the Product to an IEEE 802.1X Network
Using a Digital Certificate
Parent topic: Administering Your Product
Configuring Protocols and Services in Web Config
You can enable or disable protocols using Web Config.
1. Select or deselect the checkbox next to the service name to enable or disable a protocol.
2. Configure any other available protocol settings.
3. Click Next.
4. Click OK.
5. Select and configure services and protocol settings as necessary.
After the protocols restart, the changes are applied.
Protocol Settings
Parent topic: Using Your Product on a Secure Network