325
1. Log in to the Web Config interface as an administrator.
2. Select the Device Management tab, then select the Contacts Manager setting.
3. Select either Tile View or List View to control how the contacts are displayed on the product's LCD
screen.
4. Select an search option from the Search Options drop-down list.
5. Select OK to apply your changes.
Parent topic: Configuring Product Settings
Related tasks
Accessing the Web Config Utility
Enabling Periodic Cleaning
You can set a schedule to clean the print head using the Web Config interface.
1. Log in to the Web Config interface as an administrator.
2. Select the Device Management tab, then select the Periodic Cleaning setting.
3. Select one of the following options:
• To clean the print head after a print job, select After Printing.
• To run a cleaning cycle at a specific time, select Schedule and choose a time from the drop-down
list.
Parent topic: Configuring Product Settings
Related concepts
Print Head Cleaning
Related tasks
Accessing the Web Config Utility
Powering Off or Rebooting the Product Remotely
You can power off or reboot the product using the Web Config interface.
1. Log in to the Web Config interface as an administrator.
2. Select the Device Management tab, then select the Power setting.
3. Select a power option from the drop down menu and select Execute.
Note: After turning off the product, you cannot access Web Config until the product is turned on again.
To Next Page
Loading...
Need help?
General