❏ Placing horizontally: A4, B5, A5
Place the long edge of the original toward the paper feed entrance of the ADF or the le side of the scanner
glass.
Note:
e sizes for the following originals may not be detected correctly. If the sizes are not detected, set the size manually on the
control panel.
❏ Originals that are torn, folded, wrinkled, or curled (if the originals are curled, atten the curl before placing the
originals.)
❏ Originals with a lot of binder holes
❏ OHPs, translucent originals, or glossy originals
Available Originals for the ADF
Available Paper Sizes A6 landscape to A3/Ledger (Maximum 297×431.8 mm)
Paper Type Plain paper, High-quality paper, Recycled paper
Paper Thickness (Weight of Paper) 52 to 128 g/m
Loading Capacity 50 sheets or 5.5 mm
Even when the original meets the
specications
for media that can be placed in the ADF, it may not feed from the
ADF or the scan quality may decline depending on the paper properties or quality.
c
Important:
Do not feed photographs or valuable original artwork into the ADF. Misfeeding may wrinkle or damage the
original. Scan these documents on the scanner glass instead.
To prevent paper jams, avoid placing the following originals in the ADF. For these types, use the scanner glass.
❏ Originals that are torn, folded, wrinkled, deteriorated, or curled
❏ Originals with binder holes
❏ Originals held together with tape, staples, paper clips etc.
❏ Originals that have stickers or labels stuck to them
❏ Originals that are cut irregularly or not right angled
❏ Originals that are bound
❏ OHPs, thermal transfer paper, or carbon backs
User's Guide
Preparing the Printer
38
To Next Page
Loading...
Need help?
General