1. Open the document cover.
2. Remove any dust or stains on the scanner glass.
3. Place the original face-down and slide it to the corner mark.
Note:
❏ A range of 1.5 mm from the top edge or le edge of the scanner glass is not scanned.
❏ When originals are placed in the ADF and on the scanner glass, priority is given to the originals in the ADF.
4. Close the cover gently.
e size of the originals is automatically detected. If the size is not detected, place the originals again.
c
Important:
Do not apply too much force to the scanner glass or the document cover. Otherwise, they may be damaged.
Note:
Some sizes may not be automatically detected. In this situation, manually select the size of the originals.
User's Guide
Preparing the Printer
42
To Next Page
Loading...
Need help?
General