8 • Actuation Configurations for ICC 350
18
Position the neutral electrode on the patient. Connect neutral electrode
to the ICC 350.
of equipment trolley.
ICC 350 and APC 300.
1. Open the cylinder valves on the argon gas cylinders in a clockwise direction
until they stop.
2. Check fill level of the argon cylinders (fill level of the argon cylinders is
in the information line of the standard display). Always keep a full
replacement cylinder ready.
1. Set AUTO COAG 2 to SPRAY. Displayed: 60 (power limit 60 W)
2. Select the desired power limit.
Position P
EDAL key to AUTO COAG 2 field. Imperative!
3. Connect neutral electrode
7. Set ICC 350 for APC
8. P
EDAL
key
WARNING!
4. Plug in mains plug
5. Switch on
6. Open cylinder valves
To Next Page
