31
Actuation Configurations for ICC 350 • 8
Every time you switch between ARGON CUT and BIPOLAR CUT, the
AUTO CUT field must be reset, unless you want to use the same
parameters.
1. Screw the bacteriological filter to the argon socket .
2. Screw the argon connection to the filter.
3. Plug the multiple plug
into the multiple socket of the APC 300.
Is the automatic setting of the COAG flow / CUT flow suitable for the
application?
Press PUR key.
Press the white pedal or the blue finger switch.
Press yellow finger switch only!
AUTO START on contact, or blue foot switch.
Yellow pedal.
12. Connect APC handle
WARNING!
13. Check flow
14. Rinse applicator
15. Actuate APC
16. Actuate ARGON CUT
17. Actuate BIPOLAR COAG
18. Actuate BIPOLAR CUT
To Next Page
Loading...
