39
Actuation Configurations for ACC 450 • 8
Select a monopolar Koagulation Mode for the electrode handle at the
Cogulation socket. Select AUTO START mode. If desired select AUTO STOP
mode. Select intensity in the Autocoagulation field.
Every time you switch between monopolar and bipolar Coagulation Mode,
the Autocoagulation field must be reset, unless you want to use the same
parameters.
1. Screw the bacteriological filter to the argon socket .
2. Screw the argon connection
to the filter.
3. Plug the multiple plug into the multiple socket
of the APC 300.
Is the automatic setting of the Coag flow / Cut flow suitable for the
application?
Press P
UR key and rinse the applicator with argon.
Press the blue pedal or the blue finger switch.
Press the yellow pedal or the yellow finger switch.
AUTO START on contact
AUTO START on contact or blue finger switch.
11. Set ACC for Coagulation
WARNING!
12. Connect APC handle
13. Check flow
14. Rinse applicator
15. Actuate APC
16. Actuate ARGON CUT
17. Actuate BIPOLAR COAG
18. Actuate CUT or COAG
To Next Page
Loading...
