Erbe VIO 3 - Module-Specific Error Diagnosis; M;M-A Error Codes

6 • Remedying malfunctions
34 / 84
80116-938_V24392  2023-03
M/M-A error
Display on the unit: M or M-A, detecting module: MCM
Error code Description Additional information Action
M 1 CRC check of the program
code in the boot loader
signals an error.
Restart the unit. If the
error occurs again, notify
Erbe Service.
M 5 CAN could not be initial-
ized.
Restart the unit. If the
error occurs again, notify
Erbe Service.
M 10 – 14 Restart the unit. If the
error occurs again, notify
Erbe Service.
M 30 CAN – 120 ms timeout of
the activation message.
CAN – timeout of the
activation message from
SCM.
Restart the unit. If the
error occurs again, notify
Erbe Service.
M 31 Unknown mode identifier. A mode was activated
that is not recognized by
the MCM.
Check the accessories. If
the error persists, notify
Erbe Service.
M 32 Timeout after self-check. There was no activation
message after the self-
check.
Restart the unit. If the
error occurs again, notify
Erbe Service.
M 33 Incorrect ECB mode 
parameter received.
An incorrect effect setting
was received for the
respective mode via the
parameter messages.
Check the accessories. If
the error persists, notify
Erbe Service.
M 34 – 43 Restart the unit. If the
error occurs again, notify
Erbe Service.
M 50 – 63 Restart the unit. If the
error occurs again, notify
Erbe Service.
M 70 – 88 Restart the unit. If the
error occurs again, notify
Erbe Service.
M 100 –
105
Restart the unit. If the
error occurs again, notify
Erbe Service.
M 110 –
112
Restart the unit. If the
error occurs again, notify
Erbe Service.