232 Ion Operations Manual
Rate Master - homes to center. It adjusts the cue rate, just like rate and load.
Fader Disabled - no action is assigned to the fade.
Master Only - fader is used to set a level for content to fade to. The slider can be used to live
adjust levels when the fader has been activated via the bump button. See Master Only (on
page80) for more information.
Effect Master - masters the entry/exit mode of the effects (size, rate or both).
Levels Only - masters the levels without mastering the effect.
Temporary Fader Mapping
Presets and palettes can be used to create a temporary list of content that can be played back on a
fader.
Note: This list is not recorded. If the fader is unloaded, the list cannot be recalled.
To create a list, press the [Load] button of an unmapped fader. You can then select presets or
palettes to add to your list either by the command line or from the direct selects.
[Load] {DS 1} {DS2} {DS2} [Enter]
{Fader} [1][0] [Preset] [1] [Preset] [2] [Preset [3] [Enter]
Once mapped, the fader will default to Master Only mode. See Master Only (on page80) for more
information.
The list will use the timing assigned to the fader.
A fader with temporary mapping will have the cue list options for Back From First and Go From Last.
These are Cue List Properties, please see Cue List Properties (on page263)
The list of targets will display in the Fader Configuration List (Tab 36), in the Fader List (Tab 35), and
in the Fader Ribbon.
To Next Page
Loading...
