22
PRIMACY 2
USING THE CONTROL PANELS
LED Control panel
OFF
STEADY LIGHT
FLASHING
PRINTER READY
• The printer is ready
PROCESSING
• The printer is receiving
data.
RIBBON
• No ribbon in the printer.
• End of ribbon.
•
• The ribbon is torn.
• The ribbon is not recognised.
Check the condition of the ribbon in the printer. If you have a
print job in progress, this restarts with a new card.
CARDS
• No cards in the card feeder.
Put cards back into the feeder – the process starts again.
• Card loading error.
Check cards have been loaded. For any other problems
contact your Evolis dealer.
PRINTER COVER OPEN
• The printer cover is open.
Close the cover again. The printer starts up.
MECHANICAL ERROR
• Card jammed in the printer.
• Mechanical component fault.
Open the cover and hold down the power button in
order to eject the jammed card.
If the problem persists, contact your Evolis dealer for
assistance.
To Next Page
