Evolis PRIMACY 2 - Lamination Module Cleaning

59
PRIMACY 2
Lamination module cleaning
NOTE
Recommended cleaning cycle: once a year or every 10,000 cards, depending on the work environment.
Servicing accessory: special adhesive cleaning card.
Follow the procedure to perform a lamination module cleaning.
1

2
Launch the lamination module cleaning wizard on the
Evolis Premium Suite.
3

card.
4
Insert the adhesive card into the opening above the output hopper at
the rear side of the module. The card goes inside the printer.
5
Once the cleaning cycle is complete, the used card is ejected from
the printer.
6

38.
7
Close the door of the lamination unit. The printer is ready to oprate
again.