73
PRIMACY 2
7. DECLARATIONS OF CONFORMITY
GENERAL
Concerning Safety and Electromagnetic Compatibility of Radio Equipment
(RED 2014/53/EU, LVD 2014/35/EU, EMC 2014/30/EU Directives) and (RoHS3)
2015/863/EU:
Manufacturer name: Evolis
Manufacturer address: 14, avenue de la Fontaine
Z.I. Angers Beaucouzé
49070 Beaucouzé, France
Equipment name: Primacy 2
Year of manufacture: 2022
I, the undersigned,
Laurent Godard,
Declare under my own responsibility that the product here above described
complies with the essential applicable requirements, (particularly with those of
the RED 2014/53/EU, LVD 2014/35/EU, EMC 2014/30/EU Directives and (RoHS3)
2015/863/EU as follows:
Article 3.1 a: (electromagnetic compatibility protection requirement)
Safety standard applied EN62368-1: 2014
EN50364: 2010
Article 3.1 b: (electromagnetic compatibility protection requirements)
EMC standard applied EN55032: 2012
EN55024: 2010
EN61000-3-2: 2014
EN61000-3-3: 2013
EN301489-3: 2013 (VI.6.1)
Article 3.2: (Good use of the radio frequency spectrum to avoid undesirable interferences)
EMC standard applied EN300330-2 V1.6.1
Full name: Laurent Godard
Position: R&D Director
Date: January 4
th
2022
Signature:
EUROPE - Norway Only: This product is designed for IT power system with phase-to-phase voltage
230 V. Earth grounding is via the polarised, 3-wire power cord.
FI: “Laite on liitettävä suojamaadoitus koskettimilla varustettuun pistorasiaan”
SE: “Apparaten skall anslutas till jordat uttag”
NO: “Apparatet må tilkoples jordet stikkontakt”
DK : „Apparatets stikprop skal tilsluttes en stikkontact med jord, som giver forbindelse til
stikproppens jord“.
FCC Statement (For U.S.A.)
Federal Communications Commission Radio Frequency Interferences Statement
A, Section 15.107(a) and Section 15.109(a) Class B digital device.
Supplemental information:
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this requirement does cause harmful
interference to radio or television reception, which can be determine by turning the equipment off
and on, the user is encouraged to try to correct the interference’s by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Use of a shielded cable is required to comply within Class B limits of Part 15 of FCC Rules.
expressly approved by Evolis may cause, harmful interference and void the FCC authorization to
operate this equipment.
It is recommended to respect a distance of 20 cm between user and RFID module when the
module is powered.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
VCCI (For Japan)
This is a Class B product based on the standard of the Voluntary Control Council for Interference
from Information Technology Equipment (VCCI). If this is used near a radio or television receiver in
a domestic environment, it may cause radio interference. Install and use the equipment according
to the instruction manual.
To Next Page
Loading...
Need help?
General
