31
PRIMACY 2
Overlay settings
Overlay settings can be adjusted in the Evolis Premium Suite.
• The overlay can be applied on the whole surface of the card
• The overlay can be disabled (when lamination is applied for example)
• The overlay can be applied only on some areas of the card
• Two layers of overlay can be applied (with the YMCKOO ribbons).
NOTE
Two layers of overlay increase protection against wear and tear
Activation key
A simplex printer (prints only on one side) can be upgraded into a duplex printer (prints on both sides).
To obtain the activation key for that upgrade, contact your Evolis dealer.
Proceed as follows:
1
Turn the printer on
2
Open the printer cover.
3
Remove the ribbon
4
Insert the key as shown
To Next Page
