37
PRIMACY 2
Once the printer and lamination module are connected, follow the instructions to power the machine on.
1
Plug the lamination module to an earthed power socket
2
Plug the printer to an earthed power socket
3
Connect the printer USB cable to the computer
The system is powered on: the Primacy Lamination control panel lights up showing that the machine is working properly.
NOTE
To save energy, the printer and the lamination module automatically switch to standby mode after 10 minutes of inactivity. They
Make sure the card thickness gauge is well adjusted on the printer. See “Adjusting card thickness”, page 17.
Inserting cards and ribbon
See “Ribbons”, page 14 and See “Inserting Cards”, page 15.
To Next Page
Loading...
