42
PRIMACY 2
ENCODING OPTIONS
Encoding systems are used to customize magnetic stripes, and contact and contactless smartcards.
It is possible to install up to three types of encoder in the printer (magnetic stripe, contact and contactless smartcards) on your premises.
Magnetic stripe encoding
The Evolis encoder encodes the magnetic stripes in a single pass then runs a data check.
factory-set for high coercivity (HiCo).
Location of the magnetic encoder
The magnetic encoder is a module installed either in the factory or on site by your Evolis dealer. The read-and-write head is located under the path
taken by the cards and before the print head. The encoding sequence for a card is always carried out before the printing.
To install the magnetic encoding station:
1
Refer to the instructions provided in the kit
2
Use the installation wizard that is available in Evolis Premium Suite>Assistance & Maintenance>Maintenance>Printer Options
!
Use only magnetic stripe cards that comply with ISO 7810 and ISO 7811 standards.
The magnetic stripe must be moulded into the card to work properly.
Never use cards with a glued-on magnetic stripe.
Access the settings through Printer settings>Encoding>Magnetic.
Configure stripes to select the desired format for each stripe, according to the following table.
ISO 7811 magnetic encoding standards
To Next Page
Loading...
Need help?
General
