Changing the Loaded Clip Angle
When a clip is loaded, you can change the loaded clip angle in different ways.
How to Change the Loaded Clip Angle Using Recall Clip Toggle Mode
This mode allows you to successively call the various camera angles of the clip with its Function key.
By default, the Recall Clip Toggle mode is activated. But this can be changed from the configuration tool,
with the Recall Clip Toggle setting.
Multi PGM Mode
When a clip is loaded, pressing several times the clip Function key calls successively the next available
clip angle on each controlled PGMs.
When you press again the same clip key, the clip angle on PGM2 shifts to PGM1, the clip angle on PGM3
to PGM2 and the next clip angle is loaded on PGM3, and so on each time you press the clip key.
When all available clip angles have been loaded, the series starts again with the preferred clip angle and
the second preferred clip angle.
Single PGM
When a clip is loaded and you press the same clip Function key again, the second preferred clip angle is
loaded on the controlled PGM, then the next available clip angle, and so on. Nothing happens on the
other PGMs.
PGM+PRV
When a clip is loaded and you press the same clip Function key again, the clip angle on the PRV shifts to
the PGM, the next clip angle is loaded on the PRV, and so on.
PGM-only
When a clip is loaded and you press the same clip Function key again, the second preferred clip angle is
loaded on the PGM, then the next available clip angle, and so on.
PRVonly
When a clip is loaded and you press the same clip Function key again, the second preferred clip angle is
loaded on the PRV, then the next available clip angle, and so on.
When the Recall Clip Toggle mode is not activated, pressing several times the Function key
will load the preferred camera angle (*) of that clip on its INpoint.
USER MANUAL
LSM-VIA |6. Working with Clips| 121
To Next Page
Loading...
Need help?
General